|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Kenny J.
Email: kjosephson@sprintmail.com
Remote Name: 158.252.200.219
Date: January 13, 2003
Time: 22:40:22
I have pulled and installed flat head sixes several times over the last fifteen years. I loop the chain around the front of exhaust manifold and use a bolt, washers and nut to attach the end of the chain to a link further up. I attach the other end to a bolt in a bell housing hole on the driver's side. If this is a stick car, install the water pump after the engine is in, or you'll have clearance troubles if both the transmission and radiator core support are in place. I was always worried about breaking or cracking the front portion of the exhaust manifold, but several old time mechanics have shown me this way and I have never hurt anything doing it like this. Get some of that plastic sleeving for a bicycle lock chain and slip some over the ends near the block to protect the paint.
