Hello,I am trying to install TTI Headers on a 318 Poly in a 1964 Plymouth Belvedere.
Finally I have all of the header bolts in except one and that one is getting close to impossible. It is the lower bolt of cylinder #5 which is the third one on the driver's side. I can get it in the hole but so far I have not found a way to turn it with my fingers or any tool to get it started. I am using the bolts that came with the headers. Even though I really don't want to I have considered pulling the header back off of the driver's side and installing studs in the difficult locations.I am working on jack stands so I have limited ways I can get my hands up the the header flange. Any and all suggestions will be appreciated.ThanksDennis C.--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/067394f7-0c46-4947-b6ee-986e0704c72cn%40googlegroups.com.