Re: 8 3/4" Third Member Swap Questions?

["dennis.1963ply" <dennis.1963ply@xxxxxxxxx>]

Thanks,

That is what I've read and it was tempting however Green Axle Bearings have had a lot of bad comments.  I understand that typically satisfied people usually don't post comments and it is the few with bad luck that make all of the noise.

I was trying to make the swap easy, it did not turn out that easy but it is almost done.  I'll post my comments in a separate post.

Thanks Again

Dennis C.

On Tuesday, August 20, 2019 at 6:25:08 PM UTC-7, BCBOUND wrote:

If you switch to Green axle bearings, there is no need for the thrust blocks...

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/a272d46b-0611-4051-b00b-4ba38a6d07f1%40googlegroups.com.