Re: hood to radiator seal

[carverex@xxxxxxx]

Hi Paul

I just finished putting in a core support to hood seal from Joe on my '63 Fury. I may  be wrong, but I put the open part of the seal facing forward. I figured air pressure from incoming air would cause a better seal. Instead of installing it the other way and having incoming air trying to lay it down. Just my humble opinion.

Regards,

Lyle 

On Sunday, May 13, 2018 at 3:53:46 PM UTC-4, Paul L. http://1962to1965mopar.ornocar.org/ml-le wrote:

I purchased the newer version of the hood to radiator seal from Joe Suchy.   I have a question on installation, does the wide flat part of the seal go on the radiator side of the support?

TIA
Paul L.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.