Re: driveshaft pinion angles
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: driveshaft pinion angles



I found the smart tool to be effective.

Personally I believe people over rotate a bit trying to balance the front angle with the rear angle and in the process miss the boat that the rear angle is where the bite is lost and found.

Thank you,

Jim

On Friday, May 4, 2018 at 12:42:29 PM UTC-4, Mike wrote:
Thanks Mike, Did you look for  the inclinometer in the story? I use the plastic Moroso gauge I have but, steel tools are nicer to use.
Mike

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.