On November 26, 2017 at 5:53 PM NICHOLAS TIBERIO <furyus63@xxxxxxxxxxx> wrote:--Bill,
Last year I rebuilt the heater in my '62 Fury. At the same time I sent my heater control valve out to be rebuilt and was very satisfied with the work.
Joe Hudacek, 715-392-6169, the cost was about $90. for the rebuild & postage. One day turn around and he paid the return postage. The valve came back like new. The only negative thing was the new O-ring provided was the right ID but too large OD. I picked up an assorted O-ring package at Auto Zone for a few bucks and the right one was there.
Nick Tiberio
FuryUs63
On November 26, 2017 at 2:59 PM Bill M <y1topbanana73@xxxxxxxxx> wrote:So I think I finally determined is that my problem with no heat was due to a sticking heater control valve. When I took it out of the car, I noticed it would just lock in a closed position for an indeterminate length of time and then pop open.I have two other heater control valves that seem to operate fine, but when they're in the closed position, they seem to leak just a little tiny bit when I blow on the valve.I'm trying to decide if this bit of blow by would be acceptable, or should I try and Source in new rebuilt one? Unfortunately a rebuilt one would be pricey.Thoughts?Bill M