master cylinder ... maybe?

[neal zimmerman <neal.zimmerman@xxxxxxxxx>]

 Hi gang, doing a brake job on the cuda. Thought the master cylinder was ok but now I dont know.  Thought I would clear the lines of all old fluid. Pedal pushed it out the back lines no problem. Front lines- DEAD. Nothing would come out . Could the MC be functional in the rear only?? Or what about the proportioning block down below??

I cracked . the lines before the wheel cylinders.

   Neal Zimmerman, Eugene OR

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.