Re: How to Remove Hydraulic Lifters - Heads On

[Michael LeFevre <493mike@xxxxxxxxx>]

Hi Dan,

I've replaced many in my time and there is a tool designed for doing this service. The tool has expanding lips that register in the snap ring grooves of the tappet. Yes "varnish" can be a problem but, application of a solvent like carburetor cleaner and some soaking time will help (change oil after doing this). Good luck!

Mike

On Tue, Apr 25, 2017 at 3:00 AM, ddavids <ddavids@xxxxxxxxxx> wrote:

I'm intent on replacing the camshaft on my 64 Dodge 880  w/ 383 and I'd like to do it with the engine in the car and not pulling the heads off.

How difficult is it to remove the old valve lifters? One machinist I asked said it can be difficult because they get stuck with varnish over time.

I seem to recall there is a tool that will help yank them out. Has anyone on the list done this?

Dan Davids

Seattle

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.