front suspension damage

[neal zimmerman <neal.zimmerman@xxxxxxxxx>]

Motors out so i am going to clean, degrease and repaint engine compartment. Yesterday i notice two little cracks in the inner fenderwell metal down below  the upper shock end.  Also a slight bulging of the metal  when compared to drivers side. I got up   under the fender and sure enough the two cracks are  near the upper control arms pivot point.  The spots are behind the u-channel shaped piece that the  UCA pivot bolts pass thru and higher up the shock strut passes thru. My guess is that the car took a hit and this was the result. I looked it all over and cant see any bending of the frame rail or anything in the suspension but something has definitely happened.

  Any thoughts on what I could or should do??

   Neal Zimmerman, Eugene oregon

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.