Re: Flushing the cooling system BEFORE installing a new water pump

[James Hunt <jshunt41@xxxxxxxxx>]

Check if you have Block Drain Plugs. 

Should be near the Freeze out plugs.

Get all the nasty stuff out...

On Sunday, September 11, 2016 at 11:48:28 AM UTC-4, Douglas Sutherland wrote:

I pulled my water pump off yesterday, opened the box for the new pump

to see a yellow warning sticker taped to the inside lid of the box.

It reads:

Failure to flush cooling system prior to installation of new water pump 

is the primary cause of premature water pump failure!

So much for reading the instructions before starting the job!

I have replaced water pumps on my cars for years and have never done this but ...

I need some advice on this one.  Should I move forward with the replacement 

OR go back and reassemble and flush my system?

Thanks,

Doug

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.