Re: Drag Strip Failure Help Needed

[JimJablonski <groovinjim@xxxxxxx>]

Mounted mine inside the frame.  I made a little 90 degree bracket and welded it to inside of the rail.  Pic attached.

On Saturday, July 9, 2016 at 8:16:07 AM UTC-4, Donald Gallimore wrote:

Got the 100 Micon in front of the pump and 40 micron in front of the regulator. So, I got that right.

I'll recheck the filter flow direction.

New pump - Two votes plus ours so far. 

Has anybody mounted them on the side frame? Inside or outside of the frame? That's about the only way I see to put them below the tank. 

 

Akron Don Gallimore

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.