Throttle linkage clips

[Jason Rhoades <Jason@xxxxxxxxxxxxx>]

Question for you great knowledgeable group o car guy/gals.  I'm closing the gap on my long ram install.   The linkage I created seems to be functional as tested tonight but. What I'm looking for are those little clips that fit over the carb throttle lever then clip over the rod preventing it from falling out.  Seems the stainless steel rod I used doesn't want to be drilled for cotter pins   The rod is 1/4".  Any ideas?    Thanks all
Jason

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/d/optout.