|
When using a hex rod to prime a stock oil pump on a fresh engine – 318 Poly - will it spray all over the place with the valve covers off? Just wondering so I don’t make a huge
mess – but would like to see what is happening........ Plan is to do that before I even put the engine in the car, then put in the oil pump drive shaft and distributor while the engine is still on the stand. I am saving the torque (135 ft lb) of the dampner pulley bolt until it’s in the car and bolted to the tranny. Thanks, Ric -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout. |
Back to the Home of the Forward Look Network