Re: 383 Oil Pan Gasket Question

["Dennis C." <dennis.2914@xxxxxxxxx>]

Gary,

I don't and so far I have not been able to find out, I have not been able to find much information.  I did read a personal account where it was used on a 440 in an RV dry and did fine.  The gasket seem soft enough to seal without sealant but it would be hard for me to install it without a light skim coat of something, probably black RTV as mentioned. 

Thanks
Dennis

On Monday, July 21, 2014 10:20:36 AM UTC-7, 62to65mopar wrote:

Do you know what FelPro recommends?  

 Thanks,
 Gary H.
       >
-------Original Message------
-   ...    > Is there any reason to put any
sealant on a gasket like this except dabs in  > areas such as the rear main
carrier and timing cover area?  >   > Dennis C.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.