Hi Guys--I need some input. I installed a Stewart Warner mechanical oil pressure gauge a couple of weeks ago. I used Polyethylene tubing and compression fittings from Lowes. Specifically, I used the compression fittings with the brass collars. Delrin collars were also available. Last Saturday, while leaving to go to a cruise, the car spit the tubing out of the compression fitting and promptly pumped 3 quarts of oil everywhere! I don't want to experience this again! I'm trying to determine what I did wrong, (which may include just having the fitting too loose!) So, if anyone has information / experience regarding the use of copper V/S plastic collars on these fittings please let me know. Thanks in advance for all input, it is highly valued.Lyle63 Plymouth Sport Fury 383 4bbl.
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.
Back to the Home of the Forward Look Network