Polyheads,
I spoke with Javier at the foundry Monday this week and he told me he is
scheduled to pick up/inspect the new manifold today/Thurs. 6-5-14 for fit and
finish after the last set of machining adjustments were made – valley plate
casting adjustment, improved bolt-hole alignment/cut down bolt guide bosses for
easier intake bolt entry/mill thermostat pad/drill for water by-pass, vacuum,
heater hose, & water sending unit orifices...
Was told the valve covers are being checked & machining changes made
for the correct cast-in baffling and gasket locator tabs...I don’t have a time
estimate at this writing but will also ask that question when I get ahold of
Javier “live” today.
I will follow-up today to see if the planned “pick up” indeed happened as
Roland is “on tour” back East and buried with other duties...so I am helping out
here to keep us all informed.
Thank you!
Gary
-- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout. |