TTI header question

[JimJablonski <groovinjim@xxxxxxx>]

Folks,. I have a specific question regarding TTI headers.  Does anyone have experience comparing these two sets of headers for an RB engine:

- 2" headers (part number 440-200)

- 2-1/8" low-deck step headers (part number 400IB-218)

If so, I'd like to hear your experiences comparing the fitment, performance, etc., one against the other.

I'm not trying to ignite a debate over stepped headers.  Looking for some real-world data, preferably on a B body like mine.

Thank you,

Jim

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.