Welding cast iron can be done and is best done by someone with a lot of experience doing this job. Even welding pros take different views about the technique. If you want an overview, there is an 8-page discussion about this on "The Home Shop Machinist and The Machinist's Workshop" discussion board you can read through. http://bbs.homeshopmachinist.net/threads/47125-Cast-Iron-Manfold-Crack-Repair Thanks, Gary H. > -------Original Message------- > > Just got back and the shop got them down so they appear good to go. will put the engine back in car and give them a try. Have the other set with the cracked ears. Any one ever fix that??? Dave O ... -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out.