Re: mallory unilite hookup confusion

["Paul L. http://1962to1965mopar.ornocar.org/ml-lennemann63.html" <pjlenn@xxxxxxxxx>]

The resistors are made of alloys which do not conduct as well.   So which comes first the chicken or the egg (voltage drop or heat)?

Paul L.

On Friday, October 18, 2013 11:57:15 AM UTC-5, neal wrote:

 OK, it's getting close to fire up on the barracuda, . I wanted to double check how the previous owner had hooked up the Mallory Unilite set up, and  ( surprise, surprise!) he did it wrong according to the mallory tech sheets. Amazing it ran. Anyway they say to hook in  the red wire from their distributor to the 12 volt side of ballast resistor (with a little picture of a key and ignition switch), but according to my wiring diagrams, the dark blue wire from one side of resistor and the brown wire  on the other side of resistor both run to the ignition switch. The dark blue goes to "1" on ign. switch and brown goes to "2" on ign switch.

So which wire is the 12 volt side of resistor?? I have a feeling its the blue, but not sure.

  BTW is there a front door and  a back door to a ballast resistor or does it not care??

  Thanks , Neal Zimmerman Eugene Oregon

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.