--I had a good day and got lots done. I used my original flex plate and found the correct bolts for it. The engine is installed and mated to the trans.. The pass side headers are completed. Tomorrow I need to install the starter and the driverside headers. Then the carb kit should be here to rebuild my carb. I hope it's the right kit this time. I won't be able to put the top of the engine together until I get the replacement valve lifter.Things are beginning to click finally. Aug 17th is when it needs to be running to be in the Bellevue parade again.Let's keep our fingers crossed :-)Rich Kinsley
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/groups/opt_out.
Back to the Home of the Forward Look Network