Hyd valve adjustment

[Richard Kinsley <rlkinsley@xxxxxxxxx>]

I have a cam, lifters and pushrods that are to convert my poly from solids to hydraulic.  They were not offered in 1964 so my manual doesn't give any info.  I was of the opinion that the procedure was to rotate the cam to baseline on a valve,  tighten just to take up the slack and then turn it X turns after that.  I also need the value of X if this is correct :-) Can anyone verify this or give me the proper method?  I do realize the lifter needs to be pumped up for the process and I can do this by running the oil pump with a drill motor.

Any input will be appreciated.

Rich Kinsley '64 Dodge Polara 4dr LeRoar 324 poly w/goodies

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.