I've used the acorn style for the last two years on
the factory lugs, no problems. Warren
----- Original Message -----
Sent: Thursday, March 21, 2013 11:02
AM
Subject: Lug Nut Question on AP Torq
Thrust-Style Wheels??
Hi All, Eager to mount a set of Torq Thrust wheels on my
300K Ram. But we're running into a safety issue.
The 1/2" diameter
studs which are pressed into the hub and the drum aren't long enough. We've
tried standard lugs (LH/RH) from Classic Industries but there just isn't
enough bite to be safe. Research "suggests" that the set up should use
acorn-style lugs and not sleeve-type.
As background, the wheels are
early 1970s Torq Thrust-style units from Appliance Plating (AP) in 15x7.
Looking for information on how to safely mount these wheels on the
300. Safety is paramount and it's important that the wheels be firmly attached
to the car (for obvious reasons!).
Many thanks for any and all
advice/suggestions/leads!
David M. New Jersey
-- -- -- Please address private email -- email of interest
to only one person -- directly to that person. That is, email your parts/car
transactions and negotiations, as well as other personal messages, only to the
intended recipient. Do not just press "reply" and send your email to everyone
using the general '62-'65 Clubhouse public email address. This practice will
protect your privacy, reduce the total volume of mail and fine-tune the
content signal to Mopar topic. Thanks! 1962 to 1965 Mopar
Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html
and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. --
You received this message because you are subscribed to the Google Groups
"The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. ---
You received this message because you are subscribed to the Google Groups
"The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from
this group and stop receiving emails from it, send an email to
1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out.
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.
|