The dash was not touched, I cut a piece of black plastic to fit opening in
the dash bezel, then cut a piece of sheet metal about same size and sandwiched
them over original radio holes putting the plastic on outside, and the metal on
inside the dash area, the adjustable meter pods were then fastened to both
layers and the gauges then installed
In a message dated 2/23/2013 8:38:42 P.M. Central Standard Time,
timna74@xxxxxxxxx writes:
Did you have to cut the dash any to accommodate for the gauges -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out. |