My ballast resistor thoughts
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
My ballast resistor thoughts
- From: Richard Kinsley <leroar.kinsley058@xxxxxxxxx>
- Date: Sat, 26 Jan 2013 09:16:55 -0600
I did a lot of fiddling with ballast resistors on LeRoar and did find they made a difference. The issue with them is with overheating of the coil. You can easily run without any resistor and get a hotter spark but after awhile it may begin to overheat and the engine will sputter/die. I have a number of ballast resistors I have used. I actually have two mounted side by side on the firewall so I can switch for racing or cruising. There is a minimal difference but under severe conditions it can matter. My stock one measured .8 ohms. I use that for street driving and it actually works OK for racing. Summit had a 1 ohm and a 1.5 ohm is what came with the Mopar electronic ign as I recall. I did buy a .25 ohm from the Mopar dealer and that is my racing set-up. I can easily bypass the resistor but if i chug around too much the coil heats fairly fast and fails. So I'd say you can easily run with the resistor by-passed but if it cuts out then you have to put a resistor back in the mix. You can use the by-pass to see if the resistor is an issue without any harm to the system though. That's my opinion :-)
--
Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network