Thanks Sven and Eric. that tells me about everything I need to know.
Is there bearing, seals, and gasket kits available all together? I
searched some, but could only find individual
componets..............MO
On Jan 12, 1:37 pm, MO <mic...@xxxxxxxxxxxxxxx> wrote:
> I have a 64 Dodge 440 and the service manual for it( taper axle)
> However I am putting in a Flange axle 1965 rear houseing. Could
> someone send me or post here, a parts breakdown pic and how to adjust
> axle end play ? I know it is done on the right side, but not sure how
> it looks and how it works. And, is the wheel bearings a tight fit in
> the houseing requiring a puller? As always, I appreciate the
> input.................MO
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.