Getting ready to install the distributor. Gotta get it up on the timeing mark at TDC on the compression stroke..easy....NOT!!!!. it is a 1978 cast crank 440 The balancer has 4 timeing marks, 90 degrees apart. One has a little o beside it. Nothing on the other three marks Logical that the mark with the o woulds be TDC With turning the crank through all 4 cycles and watching the valves. It would just not come in right. Had me doubting I got the timeing chain gears correct. So on a whim, I tried dialing it in on a different mark and then it all came together. WTF ??? The internet says that only on 78-79 engines had the 4 marks on the balancer. Only one had the mark a little longer than the others. I went back and looked and yup, it was on the longer mark. So what does the little o mean beside one of the marks??? no explanation..................MO -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.