On Sun, Dec 9, 2012 at 10:08 PM, Timothy Arnold
<timna74@xxxxxxxxx> wrote:
My shift shaft seal is leaking bad on my trans. I read that most people recommend you drop the pan & remove the pump, but others say do it without removing the pan. I prefer the latter, just due to me already replacing the trans filter/oil, I thought the leak was the trans pan gasket... The tool I see is called KD-2392 but cannot seem to find where to purchase one at, anyone know of a place? I found http://atec-trans-tool.com/t-1031-a-chrysler-shiftselectorshaftsealremover-installer.aspx but not sure if it's the same?
I was reading that there is a throttle pressure shaft seal that should be replaced as well, yet I cannot find any part # for this so if anyone could help on that it would very appreciated.
Thanks!
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network