Well I did it again.I went up to Wildcat Wrecking Yard last weekend and bought another Mopar. Ed made me a sweet deal on a sweet, solid 2 door post Dart, It was funny as I went up to see a project dart he had online on his website, but when I got there I didn't really like it too much, but I spotted this one over to the side with no project number on the windshield so I figured it was just a parts car, but when I asked I found out it was just a recent arrival that they hadn't cleared yet. I crawled all through it and couldn't find any rust, and I looked everywhere, but you know once I tear into it I will find some, you always do. Anyhoo , the point of my question is swapping in a v8. It has nothing in it now, but it was an original slant six/auto car and I want to put in my 318/ 4 speed setup. What I need are the brackets on the block. getting the motor mounts is no problem, but where do I get the brackets ? I have a pair from a 67 small block cuda but I am not sure those are the same critter. Neal Zimmerman, Eugene Oregon -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.