On Sep 15, 2012, MO <micher@xxxxxxxxxxxxxxx> wrote:
On the intake side at the middle is the crossover heat port. around
that is a U shaped cavity that extends down inside the head and ends
there. What is the purpose of that?? My intake gasket is the type
that blocks off the heat port hole. but part of the U cavity is still
showing. It looks bad and would be a small bolt-screw trap. In
addition to getting debris, oil and water held in it. Is that cavity
neccessary and if not, has anyone here blocked off or filled that
cavity?
Today I finised assembly of the engine and now it is ready for
paint. HOOO- HAAAW!! .....................MO
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.