Re: ? for the engine builders
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: ? for the engine builders



You made me do some thinking,,,,,,,I knew that I had paid extra to make the  roller set up work in my 413 small block, but that was because of the lift .622,,,,, the oil hole in the lifters was rising above the lifter galley
 
In a message dated 9/5/2012 7:58:09 P.M. Central Daylight Time, 62to65mopar@xxxxxxxxxxx writes:
All the "Magnum" motors put in trucks 5.2 and 5.9 liters (318 and 360 cubic-inch) were designed to allow for hydraulic roller cam use.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
 
 


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.