You need a tool like this one Neal. http://www.ebay.com/itm/Lisle-47000-Windshield-Locking-Strip-Tool-/190666524 699?forcev4exp=true Dan -----Original Message----- From: 1962to1965mopars@xxxxxxxxxxxxxxxx [mailto:1962to1965mopars@xxxxxxxxxxxxxxxx] On Behalf Of neal zimmerman Sent: Saturday, September 01, 2012 10:27 AM To: 1962to1965mopars Subject: lockstrip replacement i got new lockstrips for the 64 cuda.... anybody have any experience replacing these?? ALSO considering popping the front and rear glass out and TRYING to reuse the old rubbers. They appear to be OK from the outside but I would like to inspect the troughs for rust and repair if necessary. I know it sounds cheap to reuse them but my pockets aren't as deep as they used to be \ Neal Zimmerman, Eugene Oregon -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.