Re: 318 Engine & 727 Transmission Removal

[Eric Sturgis <ericsturgis@xxxxxxxxx>]

According to my books they are pulled together or separate or remove the sub frame.  What ever makes you happy.  If you can pull a 383/727 I don't see why you would have any issues with a 318/727 It's a smaller block and tranny case...smaller car too but should be about the same effort to remove it.  So long as you have the height in the room you are doing it, and can raise up the car a bit for clearance from the ground it should just come out.  But you can separate them if clearance is a problem, or you can just do what I did and take the sub frame off and lift the body off and roll out the sub frame and wheels and motor and tranny.  Really just a space issue and what you feel comfortable doing.  



--

Eric

Tacoma, WA

1962 Chrysler Newport 2 door HT

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.