I don't Know if this will work on a Moar, but I
have drilled two holes in the front face of the seal- opposite each other and
installed two large sheet metal type screws into those holes. Use a claw hammer
or forked pry bar under the head of the screws and pry out. Works good for
me.....................MO
{Steve Mick}
http://stevemick1964dodge.shutterfly.com/pictures/5 -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. |