Re: New Welder Recommendations ??

["Paul L. http://1962to1965mopar.ornocar.org/ml-lennemann63.html" <pjlenn@xxxxxxxxx>]

I would also vote for the 220V. unit.  I have a 110v. Miller and 1/4" is really a stretch.  Just barely adequate.  If all you were ever going to use it for was sheet metal 110 would be fine.  But for anything heavier it's nice to have the extra heat.

Paul L.

On Monday, July 16, 2012 1:59:39 PM UTC-5, Dennis C. wrote:

I am considering a MIG welder.

A friend suggested that a 120 volt unit is all that I would need, it
would be able to weld up to 3/16" to 1/4" mild steel and that is all I
would ever need.

I have looked at some at a welding supply house and Eastwood has this
one on special:

http://www.eastwood.com/review/product/list/id/5075/?p=5

Any comments on MIG welders would be appreciated.

Thanks
Dennis C.

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.