On Jul 10, 2012, Gary H. <62to65mopar@xxxxxxxxxxx> wrote:
Is this a tool designed to R&R that seal? http://www.etoolcart.com/leversealinstaller.aspx
Thanks,
Gary H.
> -------Original Message-------
>
> You begin by taking the lever off, digging the flat rubber seal out,
> and re-installing a new seal #2464300 .
>
> Good luck
>
> Jimmy
>
>
>
>
> I have a pretty nasty trans leak in my 65 Coronet that appears to be coming
> from the kickdown pivot shaft on the top of the trans. Is this a seal of
> an "O" ring? Either way, does someone have a part number / size for it?
> Also, how do I go about changing it in the car? Looks tight as hell since I
> have dual exhaust. Sorry...not sure where to begin with this one.
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.