Nope! Jimmy On 7/10/2012 6:37 PM, Gary H. wrote:
Is this a tool designed to R&R that seal? http://www.etoolcart.com/leversealinstaller.aspx Thanks, Gary H.-------Original Message-------You begin by taking the lever off, digging the flat rubber seal out,and re-installing a new seal #2464300 .Good luck JimmyI have a pretty nasty trans leak in my 65 Coronet that appears to be comingfrom the kickdown pivot shaft on the top of the trans. Is this a seal of an "O" ring? Either way, does someone have a part number / size for it? Also, how do I go about changing it in the car? Looks tight as hell since I have dual exhaust. Sorry...not sure where to begin with this one.
-- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network