You can reduce the
fittings.
Another location I always liked was where the exhaust pipe hanger
mounts in the "hump" area.
Jimmy
On 6/26/2012 8:12 PM, Dave64 wrote:
I'm working on installing
an electric fuel pump back by the tank. The pump I have has 3/8" inlet
and outlet fittings, but my fuel lines are 5/16". Is it ok
to adapt down to the 5/16" line from the pump? Will that affect the
pressure? The pump should put out 6 lb of pressure.
I'm also trying to find the best location to
mount it. I think I'll end up putting it inside the far rear passenger
side frame rail just before the rear bumper (on the opposite side of the
bumper bracket struts). It'll be at the back corner of the tank. It'll be visable from behind, but I don't
really mind that. I don't see another place I like better that keeps
it low and stays away from the rear suspension.
Opinions please.
Thanks
Dave
'64 Belvedere 2DHT
318 Poly, Push Button
Auto
--
--
Please address private email -- email of
interest to only one person -- directly to that person. That is, email your
parts/car transactions and negotiations, as well as other personal messages,
only to the intended recipient. Do not just press "reply" and send your
email to everyone using the general '62-'65 Clubhouse public email address.
This practice will protect your privacy, reduce the total volume of mail and
fine-tune the content signal to Mopar topic. Thanks!
1962 to
1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google
Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
--
--
Please address private email -- email of interest to
only one person -- directly to that person. That is, email your parts/car
transactions and negotiations, as well as other personal messages, only to the
intended recipient. Do not just press "reply" and send your email to everyone
using the general '62-'65 Clubhouse public email address. This practice will
protect your privacy, reduce the total volume of mail and fine-tune the
content signal to Mopar topic. Thanks!
1962 to 1965 Mopar
Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups
"The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network