It is OK however working on the engine I did not think it held up as well as I would have liked to gasoline and solvents. The last time I had the intake off I painted it with Mopar's rattle can paint and now I have a couple of shades of paint on the engine. I have been told that Bill's is more of the correct color. Next time I do an engine or have the 383 out of my Sport Fury I'm going to try this paint: http://www.eastwood.com/ew-ceramic-engine-paint-qt-62-71-bb-chry-turqo.html I know Eastwood can be over priced but if anyone has used their ceramic engine paint I would be interested in their thoughts. I would like it to be sturdy by I am also concerned that the hardener will give it too much gloss. Dennis C. On May 21, 3:39 am, Ruth Gordon <kpmvn4...@xxxxxxxxx> wrote: > Hey guys. Has anyone used Bill Hirsh Hi Temp Engine paint? If so, how did > it hold up and ypur opinions please? Thanks, Ruth -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.