Re: Looking for info
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Looking for info



Lower compression will keep the detonation down in the cylinders when
you add boost. You'll also want to run a spark plug that is a step or
2 colder than stock.

- Dave

On Tue, May 15, 2012 at 2:11 PM, Roderek Soest
<awesomemau5heads@xxxxxxxxx> wrote:
> Why should I lower the compression? And if the engine blows, I will
> just put a 273.
>
> On May 15, 10:39 am, Scott Hinojos <lightspli...@xxxxxxxxx> wrote:
>> Paint probably isn't going to keep detonation in check. ;) I'd still look
>> into forged, low-compression pistons, and appropriate rings. I'd still keep
>> the boost fairly low on an engine not specifically built for boost.
>> On May 15, 2012 12:27 PM, "Roderek Soest" <awesomemau5he...@xxxxxxxxx>
>> wrote:
>>
>>
>>
>> > Its been rebuilt and I haven't even put it in the car (I am going to
>> > paint it first :p).
>>
>> > On May 15, 9:59 am, Scott Hinojos <lightspli...@xxxxxxxxx> wrote:
>> > > The fuel injection is a good idea, because it simplifies fuel metering,
>> > and
>> > > makes said metering more reliable, which helps keep the engine alive.
>> > > However, slapping a turbo on a stock, nearly 50 year old engine is not. I
>> > > would at the very least replace the rings and bearings. While you're at
>> > it,
>> > > replace the pistons with forged parts, and drop the compression ratio.
>>
>> > > Or, you could skip all that, run very low boost (~5#) and hope things
>> > hold
>> > > together. The engine could live for a while, but I wouldn't put money on
>> > > its long-term prospects.
>>
>> > > ~S~
>> > > On May 15, 2012 10:54 AM, "Roderek Soest" <awesomemau5he...@xxxxxxxxx>
>> > > wrote:
>>
>> > > > You all know that I have a 1965 plymouth barracuda. I want to install
>> > > > single port sequential fuel injection, and turbo charge in attempt to
>> > > > get better mileage and to give it more power. Has anyone done this
>> > > > before with a stock engine? Also, does anyone know where I can get a
>> > > > trans brake for a 904 tranny, that still can be driven normally? I
>> > > > have looked everywhere for this, and the only ones i found you have to
>> > > > select each gear manually to shift.
>>
>> > > > --
>> > > > --
>> > > > Please address private email -- email of interest to only one person --
>> > > > directly to that person. That is, email your parts/car transactions and
>> > > > negotiations, as well as other personal messages, only to the intended
>> > > > recipient. Do not just press "reply" and send your email to everyone
>> > using
>> > > > the general '62-'65 Clubhouse public email address. This practice will
>> > > > protect your privacy, reduce the total volume of mail and fine-tune the
>> > > > content signal to Mopar topic. Thanks!
>>
>> > > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
>> > > >http://www.1962to1965mopar.ornocar.org/mletiq.htmland
>> > > >http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
>> > > > --
>> > > > You received this message because you are subscribed to the Google
>> > Groups
>> > > > "The 1962 to 1965 Mopar Mail List Clubhouse" group.
>> > > >http://groups.google.com/group/1962to1965mopars?hl=en.
>>
>> > --
>> > --
>> > Please address private email -- email of interest to only one person --
>> > directly to that person. That is, email your parts/car transactions and
>> > negotiations, as well as other personal messages, only to the intended
>> > recipient. Do not just press "reply" and send your email to everyone using
>> > the general '62-'65 Clubhouse public email address. This practice will
>> > protect your privacy, reduce the total volume of mail and fine-tune the
>> > content signal to Mopar topic. Thanks!
>>
>> > 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
>> >http://www.1962to1965mopar.ornocar.org/mletiq.htmland
>> >http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
>> > --
>> > You received this message because you are subscribed to the Google Groups
>> > "The 1962 to 1965 Mopar Mail List Clubhouse" group.
>> >http://groups.google.com/group/1962to1965mopars?hl=en.
>
> --
> --
> Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> --
> You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> http://groups.google.com/group/1962to1965mopars?hl=en.

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.