Hammers frame connectors
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Hammers frame connectors



 We just got mine installed Sunday.  We had a bit of a problem
figuring out how to  do the rear part of the connector with the pics
and instructions that I had.  Once the slot is cut out, then it
becomes obvious  how to install.  The only other problem we had was
that the drivers side front seat and floorboard  must have been bowed
down. We simply jacked the floor back into position and then could get
the front of the connector correctly alighned with the front
crossmember. . Plenty of room on the passenger side.
    My welder/fabricator and I were very pleased with the design,
fitment,  and the quality. of the frame connectors.  And
communications with Paul were very good.  I will post some pics
later.  I give it a five star rating!...................MO

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.