Re: Frame connector install

[MO <micher@xxxxxxxxxxxxxxx>]

Thanks Dave and Dodger
  My problem is the rear of the connector where it mates to the frame
rails.  From the pics, I can't see well enough t o know.  I think that
when I cut the slot in the floor, the slot  goes up a little ways
vertically in the floor pan that then exposes the front part of the
rear frame and then it will be apparent as to how they fit together.
Hope my ace welder can get to me this week. ......................MO

On Jan 8, 11:56 pm, Dodger7...@xxxxxxx wrote:
> MO,,,,,, sounds like you have the ones where the connector protrudes above
> the floor in the rear foot area, I have not seen a set of instructions, but
> have  seen the finished product,,, it appears that to install you hold the
> connector  in place and mark the floor for the cut, you end up with a slit
> in your rear  pans just a little wider than the connector itself,,,, you then
> weld the  connector on both ends, and along the slit in pan as well, makes
> a very solid  piece when finished,,,,
>
> In a message dated 1/8/2012 10:41:02 P.M. Central Standard Time,
>
>
>
> mic...@xxxxxxxxxxxxxxx writes:- Hide quoted text -
>
> - Show quoted text -

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.