After Market Wiring Harness

["Dennis C." <dennis.2914@xxxxxxxxx>]

Hello,

I am working on the electrical system for my 63 Sport Fury.

Have any of you installed an after market wiring harness such as
Painless, Evans, or others?  If you have I would be interested in what
you installed had what you think of the product.

I was going to repair my under hood and under dash harness and add
circuits but it seems more practical to just start from scratch with a
good fuse block and new wire.  The bulkhead connector is too limiting,
it looks like the best idea is to remove it, install a plate and
grommet.  I have cruise control and a security system.  I am looking
at installing A/C and a Secret Audio unit, the number of wires that
will pass through the firewall is increasing, a grommet seems the most
practical.

I have already installed new gages and eliminated the ammeter and
replaced it with a voltmeter.

I would appreciate any suggestions.

Dennis C.

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.