Heads
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Heads



Hi all,
 
   So got a bad head gasket in the 383 in my 64 Newport Convertible, so time to pull the heads.
 
They are the original 516 castings, and, based on the variety of valve tip heights (and the fact that I had to shim the rocker shaft on one side just to get one valve to close all the way), they need some help.
 
I have a good set of 452 heads, they have the hardened seats and the larger 1.74 exhaust valves, but are open chamber heads.
 
The 383 in my car is a 1966 2-bbl engine, with 9.2:1 compression.
 
If I use the open chamber heads anyone know how much compression I will lose?
 
And with the better flow and larger exhaust valves in the 452's help make up for it in performance?
 
Any insight would be appreciated!
 
Jay

--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.