Gary,I have a very good friend that runs a frame shop and his theory is to always "replace" when ever possible.Once a spring takes a "set" it will always go back to that.If you can look around for a good frame shop and see if they can get you want in a new set of springs if possible.
-----Original Message-----
From: Gary H. <62to65mopar@xxxxxxxxxxx>
To: 1962to1965mopars <1962to1965mopars@xxxxxxxxxxxxxxxx>
Sent: Mon, Oct 3, 2011 9:46 pm
Subject: Re: Leaf spring rearch questions
Oops. That should have been re-arching leaf springs / rebuilding them. Sorry for
the typo in the mail itself....
> -------Original Message-------
> From: Gary H.
>
> Hi all,
>
> Any thoughts on reaching leaf springs? Specifically, tell the shop to go
back to stock specs or to make the leaf springs so that the rear of the Mopar is
about 1/2" higher than stock? Or?
>
> Thanks,
> Gary H.
>
> --
--
--
Please address private mail -- mail of interest to only one person -- directly
to that person. That is, send parts/car transactions and negotiations as well as
other personal messages only to the intended recipient, not to the Clubhouse
public address. This practice will protect your privacy, reduce the total volume
of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The
1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network