Fw: Poly parts available

["Gary Pavlovich" <glpavlovich@xxxxxxx>]

Polyheads,

 

I have contact in El Paso, TX with the following parts for sale if you need them:

 

1965 Poly 318 – diassembled; cleaned, tanked, magged – all OK

1965 727 318 Poly Torqueflite w/convertor – running fine w/motor till disassembly of engine

Dual Quad cast iron Poly intake with machined carb pads to accept Edelbrock AFB’s without the need for adapters’

HOT Street Poly Cam – 264/.450” (222@.050”) 108LC solid cam

New Eagle SIR small block Mopar rods and a boatload of other parts.

 

Let me know of any interest and I will forward you the person’s e-mail so you can make contact.

 

Thank you,

Gary Pavlovich

 

http://www.picupine.com/ed0e5d0x – pictures of the dual quad, engine & trans...located here.

--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.