On Sat, Jun 25, 2011 at 9:23 AM, Jacob Fox
<imfast101@xxxxxxxxx> wrote:
Sent from my iPhone
On Jun 25, 2011, at 8:53 AM, Afterhours Fabrication <afterhoursfab@xxxxxxxxx> wrote:
> Welcome, I have a '62 880, they're fun cars. The picture of the horn
> ring didnt work for me, but its most likely pot metal, or white metal.
> It has a very low melting temperature so you can't weld it, and I
> doubt solder will hold. It will need to be brazed, but you can also
> try these specialty rods from a company such as Muggy Weld:
>
> http://www.muggyweld.com/index2.html
>
> They def work but it takes a bit of practice to get it right. You can
> do the repair with a propane torch but MAP gas or acetylene will work
> faster/better depending on the metal.
>
> - Dave
>
>
>
> On Sat, Jun 25, 2011 at 5:54 AM, Jacob Fox <imfast101@xxxxxxxxx> wrote:
>> Another question: that horn ring base is like a cast aluminum it seems...can
>> you solder that? There's prolly no chance in me finding another one...I
>> tried to jb weld it to no avail
>>
>
> --
> --
> Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> --
> You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network