Re: Brake Light Switch (was Electrical question)

[MO <micher@xxxxxxxxxxxxxxx>]

Dave ,  IIRC there is an extension of the rod that comes out of the
master cylinder to the brake pedal  on past the attaching bolt-
bushing. That extension pushes on the brake light switch.  I am pretty
sure that is the way on my 64 Dodge non- power
brakes.......................MO.

On Jun 9, 9:17 pm, Dave64 <lt7d...@xxxxxxxxx> wrote:
> I was fooling with mine this afternoon.  I found that the plunger was all gummed up inside the switch.  I sprayed it up with WD-40 to get it working again (must be a spring inside that was sticking).  So it seems to be working fine now.  A couple of questions, though.  
>
> The end of the plunger has a knob on it that looks like it should line up with a larger part of the pedal mechanism, but mine lines up with a skinny part of the pedal.  Perhaps that's correct?  The bracket the switch is attached to is slightly loose, so the switch doesn't seem to stay in the exact proper location and the brake lights now stay on unless I pull up on the pedal.  I tried to get to the bolt that tightens the bracket up, but what a bugger that is to reach and get a wrench on.  My daughter has some success getting in there with the instrument panel removed.  But she had to go to work before I got things finished up.  We'll try it again when we have time.  I'm thinking a new switch would be a good idea anyway, but looking for any tips you guys may have on the position of the switch and getting to that mounting bolt above the steering column.
>
> Thanks,
>
> Dave
> '64 Belvedere
>
> --- On Wed, 6/8/11, 64-polara <wchus...@xxxxxxxxxx> wrote:
>
>
>
> > From: 64-polara <wchus...@xxxxxxxxxx>
> > Subject: Re: Electrical question
> > To: "The 1962 to 1965 Mopar Mail List Clubhouse" <1962to1965mopars@xxxxxxxxxxxxxxxx>
> > Date: Wednesday, June 8, 2011, 7:15 AM
> > My brake lights now work. I cleaned
> > off the terminals and shot some
> > electrical contact spray on them and in the plunger area on
> > the switch
> > and it works great but will probably  buy a switch and
> > replace it
> > anyway, they are reasonably priced.
>
> > i did pull the grounding strap on the fuel tank and sanded
> > the gas
> > lines. With my handy dremel tool cleaned out the contact
> > surfaces on
> > the strap, still nothing. So I will do some testing on the
> > sending
> > unit and clean some other connections to make sure I have a
> > good
> > ground. So will see what happens. Could be the voltage
> > limiter in the
> > cluster too.
> > On Jun 5, 8:36 am, "Ollie" <satellite1...@xxxxxxxxxxx>
> > wrote:
> > > I suspect that the brake light problem is in the turn
> > signal switch. I have
> > > had 2, 65 Plys and both have  the same problem.
> > Wiggle the turn signal lever
> > > and the brake lights will go on and off. Always the
> > right side on both mine.
> > > Ollie
>
> > > -----Original Message-----
> > > From: Dave64
> > > Sent: Sunday, June 05, 2011 8:07 AM
> > > To: 1962to1965mopars@xxxxxxxxxxxxxxxx
> > > Subject: Re: Electrical question
>
> > > Another possibilty on your brake lights could be the
> > turn signal switch.  I
> > > think mine is bad - intermittently works/doesn't work.
> >  I have a new Daniel
> > > Stern switch on the bench - just need to get around to
> > installing it.
>
> > > Dave
>
> > > --- On Thu, 6/2/11, 64-polara <wchus...@xxxxxxxxxx>
> > wrote:
>
> > > > From: 64-polara <wchus...@xxxxxxxxxx>
> > > > Subject: Re: Electrical question
> > > > To: "The 1962 to 1965 Mopar Mail List Clubhouse"
> > > > <1962to1965mopars@xxxxxxxxxxxxxxxx>
> > > > Date: Thursday, June 2, 2011, 10:04 AM
> > > > Yup
> > > > all of the other lights were working. I will
> > check the
> > > > ground strap
> > > > and I had thought about the switch and doing what
> > you said.
> > > > Will check
> > > > it out tonight.
> > > > Thanks
>
> > > > On Jun 2, 7:37 am, Dodger7...@xxxxxxx
> > > > wrote:
> > > > > Fuel gauge,,,,,,, did the rest of your
> > gauges work
> > > > properly? if so it is
> > > > > more than likely the ground strap
>
> > > > > Brake lights,,,,, did your interior lights,
> > and dash
> > > > lights work ? if not
> > > > > check fuses, if they did work, jumper the
> > wires at the
> > > > brake light switch,
> > > > > if  they work then, it is the switch,,,, if
> > they
> > > > still do not work, I would
> > > > > find the  rear chassis harness plug
> > connection, and
> > > > check for corrusion, both
> > > > > your  taillights and fuel gauge probably go
> > through
> > > > that same plug,,,
>
> > > > > In a message dated 6/2/2011 6:47:42 A.M.
> > Central
> > > > Daylight Time,
>
> > > > > wchus...@xxxxxxxxxx
> > > > writes:
>
> > > > > Well the  Polara rolled out of the garage
> > under its
> > > > own power yesterday
> > > > > afternoon.  What a great feeling after its
> > innards
> > > > and outards
> > > > > cluttering up my garage  for the last
> > year.
>
> > > > > I replaced the fuel sending unit about 4
> > years ago.
> > > >  While the car had
> > > > > been in my garage waiting to go back
> > together the gas
> > > >  guage had been
> > > > > working fine. Yesterday started it up drove
> > it a few
> > > > miles  and it was
> > > > > ok just low on gas. About an hour later
> > after putting
> > > > the wheel  covers
> > > > > back on I start it up and the guage is
> > bottomed out
> > > > below the  E
> > > > > mark.So I shut it off, start it up again
> > same thing.
> > > > Get some gas  in
> > > > > it, still the same thing. Later took my wife
> > out to DQ
> > > > as a  little
> > > > > celebration and cruise so while waiting in
> > line the
> > > > guage starts  to
> > > > > move in the full direction then stopped and
> > went to
> > > > empty again.
> > > > > I  will check out the fuel sending unit
> > wires and
> > > > ground strap
> > > > > tonight.Anybody  have any thoughts on
> > that?
>
> > > > > Next issue. Brake lights were working fine
> >  before
> > > > yesterday. Now they
> > > > > are not. Noticed that at Dairy Queen  also
> > > > > when i didnt see my brake light reflection
> > in the big
> > > > aXX  Navigator
> > > > > behind me. Maybe the switch for the brake
> > light at the
> > > > pedal? if  so
> > > > > what would be a good source to get it from?
>
> > > > > Other than that it  was a great feeling to
> > be back in
> > > > the bucket seats
> > > > > again all 4 windows  down.
>
> > > > > Will post some pics soon.
>
> > > > > --
> > > > > You received this message  because you are
> > subscribed
> > > > to the Google Groups
> > > > > "The 1962 to 1965 Mopar Mail  List
> > Clubhouse" group.
> > > > > To post to this group, send email to  1962to1965mopars@xxxxxxxxxxxxxxxxx
> > > > > To unsubscribe from this group, send  email
> > to
> > > > > 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
> > > > > For more options,  visit this group at
> > > > >http://groups.google.com/group/1962to1965mopars?hl=en.
>
> > > > --
> > > > You received this message because you are
> > subscribed to the
> > > > Google Groups "The 1962 to 1965 Mopar Mail List
> > Clubhouse"
> > > > group.
> > > > To post to this group, send email to 1962to1965mopars@xxxxxxxxxxxxxxxxx
> > > > To unsubscribe from this group, send email to
> > > > 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
> > > > For more options, visit this group at
> > > >http://groups.google.com/group/1962to1965mopars?hl=en.
>
> > > --
> > > You received this message because you are subscribed
> > to the Google Groups
> > > "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> > > To post to this group, send email to 1962to1965mopars@xxxxxxxxxxxxxxxxx
> > > To unsubscribe from this group, send email to
> > > 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
> > > For more options, visit this group athttp://groups.google.com/group/1962to1965mopars?hl=en.-
> > Hide quoted text -
>
> > > - Show quoted text -
>
> > --
> > You received this message because you are subscribed to the
> > Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse"
> > group.
> > To post to this group, send email to 1962to1965mopars@xxxxxxxxxxxxxxxxx
> > To unsubscribe from this group, send email to
> > 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
> > For more options, visit this group athttp://groups.google.com/group/1962to1965mopars?hl=en.- Hide quoted text -
>
> - Show quoted text -

-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To post to this group, send email to 1962to1965mopars@xxxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/1962to1965mopars?hl=en.