Re: Off subject -cast iron

[Jimmy Peavy <peaver63@xxxxxxxxxxxxxx>]

Sure it can.
I once had a Buick V6 and I chopped off the exhaust outlets  to enable 
me to re-route the exhausts from the rear to the  front exits.
I swapped the left side manifold to the right side, and the right side 
to the left.
I ground each side to a bevel, and welded it up with nickle rods. .No 
preheating, etc.
Just welded them up.
Those manifold outlets never turned loose.
That was 40 yrs ago.
They make cast iron rods now.

  Jimmy

On 5/29/2011 8:52 AM, DJ wrote:
> This a question about a 65 lawn mower, motor mount broken, can cast
> iron be welded, if so, what are the chance of it fixing the problem or
> will it just break again?

--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To post to this group, send email to 1962to1965mopars@xxxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/1962to1965mopars?hl=en.