That's correct!
You just can't swap a yoke off of a 742/489 to a 741 case.
Jimmy
On 5/12/2011 10:26 AM, Gary Wilson wrote:
They are both 741 case's then it should be no problem
to swap yokes. They should be the same.
On Wed, May 11, 2011 at 11:41 PM, MO <micher@xxxxxxxxxxxxxxx>
wrote:
If he wanted to, couldn't he also change
yokes to fit his current
driveshaft U-joint?..................MO
On May 11, 10:55 pm, < 62to65mo...@xxxxxxxxxxx>
wrote:
> Noisy is not a good sign. You have to remove the center
anyway, so someone can look at the wear patterns and give an
educated evaluation. May be cheaper to replace it with a
known good 8.75.
>
> Thanks,
> Gary H.
>
> > > Also, do you think it would be worth it to
take the pod out and take it into a shop to see if they can
set it up properly, or is the damage probably done?
>
>
>
>
>
> > > As usual any insight would be appreciated!
>
>
> - Show quoted text -
--
Gwwilson
--
You received this message because you are subscribed to the Google
Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To post to this group, send email to
1962to1965mopars@xxxxxxxxxxxxxxxx.
To unsubscribe from this group, send email to
1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit this group at
http://groups.google.com/group/1962to1965mopars?hl=en.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To post to this group, send email to 1962to1965mopars@xxxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/1962to1965mopars?hl=en.
|
Back to the Home of the Forward Look Network