Hi Guys, I'm stripping my '62 Dodge Phoenix (same a 4 door Dart) so it is ready for paint. However, I am stuck - can someone advise the easiest way to remove the window crank handles?? I have a Dart, Lancer & Polara workshop manual ... but it refers to a special tool. Is there another way of getting them off without this tool so that I can remove the door panels, etc. As you can imagine special tools would be rare here in the land down under. Additionally, I need instructions on removing the back seat base. I'm guessing it needs a good thump along the front of the base, and lifting at the same time. I look forward to the responses from those who have tackled these tasks in the past. Cheers, Tony Gold Coast Australia ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.